Home > Knowledge > Content
European and American plastic mold export standards
May 09, 2018

European and American plastic mold export standards:

1. Mold base : adopt the "LKM" mould frame.

2. Guide column inversion (front die guide post, rear die guide sleeve).

3. Two tubes must be placed between the panel and the A board.

4. The thimble board must have a guide post (ejector guide bush  ).

5. Steel: commonly used with hard materials :LKM2083, LKM2344, LKM2767. Generally hard to 52-54hrc.

6. locating ring: the locating ring should be 4mm higher than the panel, and the locating ring should be 4mm higher than the insulation board if there is a heat shield.Commonly used locating ring diameter: Ø90、Ø100、Ø110、Ø120、Ø125、Ø150、Ø160

7. The two types of FLAT(FLAT) and R15.5.Arc of pumping mouth opening minimum guarantee: Ø 3.5 mm.

8. The "DME" "HASCO" standard is adopted for the ejector pin and ejector sleeve .


plastic injection tooling : 


plastic injection tooling


We're Here to Help

  • +8613532710267

    +86-769-84966110

    Email:tammytan@vip.126.com

    No.8 Bulding 1, Zhengqiangda Industrial Park,Lianfengxinroad, Dalingshan Town, Dongguan City, Guangdong, China

Newsletter

Enter in your email address to receive deals
and coupons.
Bookmark us today!